Cordless Wet/Dry Vacuum Cleaner
™
by Wagan Tech
®
3
www.wagan.com
©2012 Wagan Corporation. All Rights Reserved.
Wagan Tech and
wagan.com
are trademarks used by Wagan Corporation.
User’s Manual—Read before using this equipment
4
CHARGING
1. Set “ON/OFF” switch into the “OFF” position.
2. Set unit into charging base.
3. Ensure that the indicator light is on. If it is not, repeat steps 1 & 2.
Note: In order to maximize the suction power, the vacuum should be
fully charged for at least 24 hours before first use.
4. After the initial charge, the vacuum will require 8–12 hours for a full
charge.
5. The vacuum will run for roughly 15 minutes on a full charge.
VACUUMING LIQUIDS
1. Before vacuuming liquids, empty the Dust Bin compartment.
2. Place the vacuum vertically, keep the nozzles downward and check the
liquid level.
3. Never point the nozzles upward with liquids to prevent leaking.
4. It is recommended to empty the Dust Bin compartment immediately
when the liquid level reaches the “Max” line. If the compartment
contents exceed this designated level, permanent damage to the
vacuum can result.
5. After the Dust Bin compartment and filter are fully dried, reassemble the
vacuum.
PRECAUTION
In case of abnormal operation such as motor overheating, turn off the
vacuum cleaner and solve the problem first (e.g. blockages in the vacuum
inlet or accessories). If the vacuumed dust or debris fall out from the vacuum
cleaner, check to see if the filter is full and in need of cleaning.
MAINTENANCE
• Store the vacuum cleaner in a clean, dry area when not in use.
• Check the condition of the filter regularly, and make sure that it is firmly
in place. If the vacuum cleaner loses suction power or makes abnormal
noises, open it and check if the vacuum cleaner inlet is blocked.
• Empty the Dust Bin compartment regularly if you have vacuumed dust.
• Check if the filter is full. The filter is reusable and washable.
