Install outer handle set on the
door.
outer handle set.
Install the spindle on the outer
handle set and use hexagon
driver (#1.5) to tighten the spindle.
The screw hole of the spindle
must be at the bottom and the
mark of the coupling must be on
the top.
Drill the holes on the door
according to the Door Drilling
Template.
If there is an existing mortise
lock, remove it before drilling.
Place the Door Drilling Template
on the door.
Use a pin driver to mark the
point where you need to drill.
Take away the handle of the
inner handle set and turn the
screw at the bottom of inner
handle set clockwise (go inside)
until the cover plate can be
pulled out.
Put the cover plate on the inner
handle set.
Turn the screw at the bottom of
the inner handle set anti-clock-
wise (go outside) until you feel
resistance.
Install the inner handle and use
hexagon driver (#3.0) to tighten
the screw on both inner and
outer handle.
Install CR2 lithium battery and
install the battery holder back to
the outer handle set.
Use hexagon driver (#1.5) to turn
the screw at the bottom of outer
handle set anti-clockwise then
pull out the battery holder.
12
11
10
9
8
1
2
3
4
5
6
Install inner handle set on the
door, and screw the outer
handle set and inner handle set
tightly.
7
INSTALLATION GUIDE
