Waeco Switch200VTO, Installation And Operating Manual

Page: 22 / 168

Installing and connecting the control box PerfectView SWITCH200VTO
EN
22
6 Installing and connecting the control box
6.1 Tools required
For installation and assembly , you will need the following tools:
 Measuring ruler (fig. 4 4, page 4)
 Centre punch (fig. 4 5, page 4)
 Hammer (fig. 4 6, page 4)
 Drill bit set (fig. 4 7, page 4)
 Electric drill (fig. 4 8, page 4)

Screwdriver (fig.
4
9, page 4)
To establish and test the electrical connection , the following tools are required:
 Diode test lamp (fig. 4 1, page 4) or voltmeter (fig. 4 2, page 4)
 Insulating tape

Heat shrinking sleeve
 Hot air blower (fig. 4 10, page 4)
 Crimping tool (fig. 4 11, page 4)
 Soldering iron (optional) (fig. 4 12, page 4)
 Solder (optional) (fig. 4 13, page 4)

Cable bushing sleeves (optional)
To fasten the cables you may require additional cable binders.
6.2 Mounting the control box
The control is supplied ready for installation.
➤
Install the control box in a location protected from water near the monitor, preferably
under the dashboard.
Make sure you consider the length of the cable.
➤
Attach the control box using the supplied screws.