Mounting the monitor
PerfectView M7LS
EN
34
7.4
Connecting the monitor to an electricity supply (fig.
f
, page 10)
The circuit diagram for the monitor can be found in fig.
f
, page 10.
Observe the following instructions when laying the connection cable:
z
Feed the connection cable through existing ducts or other openings where possible
e. g. ventilation grilles. If no appropriate ducts or openings are available you will need
to drill a hole of
∅
18 mm. Check beforehand that there is sufficient space on the other
side for the drill head to come out (fig.
2
, page 4).
z
Please observe the notes from the chapter “General information on the electrical con-
nections” on page 30.
➤
Lay the monitor cable on the dashboard.
➤
Insert the plug of the monitor cable (
2
) in the socket (
4
) of the connection cable (
3
).
A
NOTICE!
Make sure the polarity is correct when connecting to a voltage source.
No.
Description
1
Monitor
2
13-pin DIN plug
3
Connection cable
4
13-pin DIN socket
5
12 V positive cable (red): Connection to the positive pole of the voltage
source
6
Earth cable (black): Connection to the negative pole of the voltage source
7
6-pin DIN socket
8
Cable (green): Control input for the connection to the reversing lights
9
6-pin mini DIN plug
10
System cable
11
6-pin mini DIN socket
12
6-pin mini DIN plug
13
Camera
_M7LS.book Seite 34 Freitag, 14. Oktober 2011 5:32 17
Summary of Contents for PerfectView M7LS
Page 4: ...PerfectView M7LS 4 2 3 4 5 _M7LS book Seite 4 Freitag 14 Oktober 2011 5 32 17...
Page 6: ...PerfectView M7LS 6 A B 9 0 a _M7LS book Seite 6 Freitag 14 Oktober 2011 5 32 17...
Page 7: ...PerfectView M7LS 7 b _M7LS book Seite 7 Freitag 14 Oktober 2011 5 32 17...
Page 9: ...PerfectView M7LS 9 1 3 2 4 e _M7LS book Seite 9 Freitag 14 Oktober 2011 5 32 17...
