Using the LCD monitor
PerfectView M55LX, M75LX
EN
18
This control cable is used as a signal cable for the activation of a side camera when an indicator is
flashing, for example.
➤
If necessary, connect the CAM1 socket (
9
) of the connection cable to the plug of video source
1 (e.g. reversing camera).
➤
If necessary, connect the CAM2 socket (
10
) of the connection cable to the plug of the video
source 2 (e.g. side camera).
➤
If necessary, connect the CAM3 socket (
11
) of the connection cable to the plug of video source
3 (e.g. camera).
I
Connecting an additional reversing camera (trailer operation)
➤
If necessary, connect socket CAM4 (
12
) of the connection cable to the plug of the additional
reversing camera.
8
Using the LCD monitor
8.1
Switching on the monitor
➤
If the monitor is switched off, press the
P
button (fig.
0
2, page 5) to switch the monitor on.
➤
The button lights up green.
✓
The picture appears.
8.2
Switching off the monitor
➤
Press the
P
button (fig.
0
2, page 5) to switch off the monitor.
➤
The button lights up red.
✓
The picture disappears.
NOTE
Observe the power consumption of the video system. The cameras are equipped with
heaters. A maximum current of 1.5 A can flow (three cameras in heating mode). Use a
disconnector switch for direct connection to the battery. This allows you to disconnect
the video system from the battery easily if you are no longer using the vehicle.
M55LX-M75LX-IO-16s.book Seite 18 Mittwoch, 20. Dezember 2017 1:51 13
