MagicSafe MSG150
Connecting the gas detector
23
Permanently wiring the MSG-150
If you wish to give the gas detector a permanently wired connection and switch it on with
the RV-AMP-SW additional switch, please use the circuit diagram
9
, page 6.
➤
Disconnect the 12/24 V plug from the cable.
➤
Remove around 10 cm of the outer insulation on the end of the cable.
➤
Connect the black, yellow and orange cable to the bodywork earth (terminal 31).
➤
Connect the red cable to the output of the RV-AMP-SW additional switch.
➤
Connect the input of the switch with a 1 A fuse to the positive battery pole.
8.2
In combination with the MS-620SI external siren
If you wish to connect the gas detector with the MS-620SI external siren, please use the
circuit diagram
0
, page 6.
Mounting the external siren
The external siren can be mounted in the engine compartment.
When mounting it, ensure that the installation location is
z
Not
in an area exposed to splashing water
z
Not
near the exhaust system
z
Cannot
be accessed from underneath the vehicle, to ensure that it cannot be sabo-
taged
➤
Mount the external siren with the acoustic horn facing downwards.
Connecting the alarm siren
➤
Connect the black cable of the siren to the bodywork earth (terminal 31).
➤
Connect the red cable of the MS-620SI siren to the relay contact 2 (
3
2, page 4).
➤
Connect the relay contact 1 (
3
1, page 4) to 12 V continuous positive.
The cable must be fused with at least a 1 A fuse.
Note:
If your vehicle does not have a 12 V continuous positive cable in the mounting
area, you can also connect the input to the battery via a 1 A fuse.
MSG-150.book Seite 23 Donnerstag, 30. Oktober 2008 5:03 17
