Waeco MagicComfort MSH 300, Installation And Operating Manual

Page: 27 / 192

EN
MagicComfort MSH300, MSH301 Installing the seat heater
27
Installing the heating element for the seat surface
➤
Insert the heating element for the seat surface between the cover fabric
and the foam core of the seat (fig.
b , page 4).
➤
If anchoring grooves are present, make sure that the cut-out sections are
positioned over the anchoring grooves (fig.
c , page 4) and place the
heating elements in the anchoring grooves.
➤
Fasten the heating element using double-sided adhesive tape to prevent
it sliding on the foam core.
Ensure that no creases or kinks form.
Installing the heating element for the backrest
A
➤ Open the lower area of the backrest cover (fig. d , page 4).
➤ Push the heating element into the gap between the seat cover and the
seat cushion (fig.
e , page 4).
➤ Fasten the heating element using double-sided adhesive tape to prevent
creases.
Installing the seat
➤ Reassemble the backrest and seat.
➤ Lift the seat into the vehicle.
➤ Secure the vehicle seat with the fastening screws.
NOTICE!
If the seats are equipped with side airbags, then there is a prede-
termined breaking point in the cover fabric. The seat cover must
therefore not be pulled tightly or slip out of place.