Waeco Coolair CA850S, Installation Manual

Page: 30 / 160

Installation
CoolAir
30
6.2 Steps for installation
a Caution
The manufacturer only assumes liability for parts included in the scope of
delivery. The validity of the warranty expires if the device is installed
together with third-party parts.
a
Caution
Check whether the roof of the vehicle is able to support the weight of a
person before climbing onto it. Ask the vehicle manufacturer about the
permitted roof loads.
6.2.1 Removing the sunroof
➤ Remove all screws and fixtures of the existing sunroof.
➤
Take out the sunroof.
➤
Remove the sealant around the opening, so that the surface is clean
and free of grease.
I Note
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
6.2.2 Preparing the unit
I Note
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤
Place the air conditioning roof unit on a work surface with the housing
facing down.
a Caution
Screw in the thread insert vertically.
Do not exceed the screw torque of 10 Nm.
➤
Screw in the 4 self-threading M8 thread inserts in the blind holes
marked with “1” (fig.
3 on page 3, item 1).
Use the supplied 1/4" bit for this.
CA-850S_EBA.book Seite 30 Mittwoch, 8. September 2010 7:31 19