Other Control Displays
This is the Laundryprint main screen and is normally displayed if the system is
not in keyboard mode.
Exiting out of keyboard mode may be the result of pressing the
Esc
key too
many times
(whilst exiting label edit mode)
or non detection of a keyboard
connected. Check that the keyboard is connected correctly and press the
F1
key to go back to Keyboard mode or reset the printer by switching it off / on.
If a fault is detected the screen will toggle between the two displays below, note the LED’s at the top of the
panel are also illuminated
(see fig 10).
Check that the thermal tape or ribbon
has not run out and that the print head
has been closed correctly.
Control Panel
It should not be necessary under normal printing to access the control panel buttons as most of the standard
label printing functions can be accessed via the keyboard.
Feed Key
When printing with continuous media, pressing the FEED key will feed media out to a certain length. When
printing with gap labels, pressing the FEED key will feed one label at a time
Pause Key
When pressing the Pause key in standby mode (ready to print), the printer will go into the Pause Mode, and
LCD Display will indicate “Pause”. At this status, printer is not able to receive any command. Then pressing
the Pause key once again, the printer will get out of the Pause mode and go back to standby mode.
Pressing the Pause key while printing, printer will suspend the print job. When the Pause key is pressed one
more time, the printer will continue with the rest of the print job. For example, when printing with a print job
that contains 10 labels and then press the Pause key to suspend the print job after 2 labels are printed out. If
the Pause key is pressed again, the printer will print out remaining 8 labels to complete the print job.
Cancel Key
The Cancel key is used to cancel current print job. The LCD Display will show “Print job is cancelled” when
pressing the Cancel key during printing. For example, when printing with a print job that contains 10 labels
and then press the Cancel key after 2 labels are printed out. The remaining 8 labels will not be printed, and
the printer goes back to standby mode.
5
Fig – 8/9
