Wacom Intuos3 12x19, User Manual

Page: 62 / 92

T
ROUBLESHOOTING
I
NDEX
C
ONTENTS
I
NDEX
C
ONTENTS
62
62
Double-clicking is difficult. Be sure you are quickly tapping the tablet twice in the same place on the
tablet’s active area.
Using the side switch to double-click is recommended (review the
techniques in
clicking ). See also adjusting tip feel and double-click .
Set one of the ExpressKeys to D
OUBLE
C
LICK
and use it to issue double-
clicks.
Try increasing the T
IP
D
OUBLE
C
LICK
D
ISTANCE
(see adjusting tip feel and
double-click ).
Try using a lighter T
IP
F
EEL
(see adjusting tip feel and double-click ).
Windows: Try setting your system to launch programs with a single click.
See clicking .
The pen selects
everything, will not stop
drawing.
Open the Wacom Tablet control panel and go to the P
EN
tab. Move the T
IP
F
EEL
slider toward F
IRM
, or select the D
ETAILS
... button and increase the
C
LICK
T
HRESHOLD
setting. If this does not help, see testing your tools .
The eraser selects
everything or will not stop
erasing. Open the Wacom Tablet control panel and go to the E
RASER
tab. Move the
E
RASER
F
EEL
slider toward F
IRM
, or select the D
ETAILS
... button and
increase the C
LICK
T
HRESHOLD
setting. If this does not help, see testing
your tools .
You notice a delay at the
beginning of pen strokes. Try decreasing the T
IP
D
OUBLE
C
LICK
D
ISTANCE
(see adjusting tip feel and
double-click ). If that does not work, try dragging the T
IP
D
OUBLE
C
LICK
D
ISTANCE
slider to the O
FF
position in order to turn off double-click assist.
You have to press hard
with the pen when clicking
or drawing.
Open the Wacom Tablet control panel and go to the P
EN
tab. Move the T
IP
F
EEL
slider toward S
OFT
, or select the D
ETAILS
... button and decrease the
S
ENSITIVITY
and C
LICK
T
HRESHOLD
settings
The pen tip does not
function. Make sure the status LED changes from blue to green when the tip is
pressed. If it does not, you may have defective hardware (see
testing your
tools ).
Check the control panel’s P
EN
tab and verify that the tip is assigned to a
C
LICK
function.
Changing the function
settings for the Intuos3
tools has no effect. Make sure that you change the settings for the tool and the application that
you are using. See
working with multiple tools and working with application-
specific settings .