Wacom DTU-1931, Installation Manual & User Manual

Page: 17 / 172

Installation
Page 13
LCD MONITOR CABLING DIAGRAM
C
AUTION
Make sure your video card has a VGA or DVI connector, and that you correctly set the DVI/VGA switch
for the video connector you are using.
Do not attach the USB data cable until instructed to do so.
– A –
DVI/VGA switch
Use the DVI-I
OUT
port to
connect a second device,
such as a projector or
monitor, that mirrors the pen
display.
Fully install the DTU-1931
hardware and software
before connecting a
projection device to the unit.
– B –
Analog RGB cable
or
DVI to DVI cable
VGA or DVI
video card
DVI
IN
Rear panel
of computer
– C –
DC input
To AC outlet
Power adapter
– D –
C
AUTION
Do not connect or disconnect the video or power cables while the DTU-1931 or your computer are
turned on –
this can damage the display or computer video card.
Use only the power adapter that came with the DTU-1931; use of an improper power adapter may
damage the unit.
Make sure that the display refresh rate does not exceed 75 Hz.
Analog (VGA)
Digital (DVI)
DTU193_Manual.fm Page 13 Monday, September 15, 2008 2:42 PM