IREN
Operation
21
7.2
Starting up
Connecting the machine to the power supply
The machine may only be connected to a three-phase inverter, connection val-
ues see chapter
Technical Data
.
1. Turn off ON/OFF switch.
Note:
When the ON/OFF switch is pressed, the machine starts to run imme-
diately at the connection. The machine can strike out and may injure persons
or be damaged.
2. If required, connect the machine to a permitted extension cable.
Note:
See chapter
Technical data
for the permitted lengths and cross-section
areas of extension cables.
3. Connect the power cable or extension cable to the inverter.
Switching IREN on
1. Use the protective hose to hold the machine near the vibrator head.
2. Switch on the machine via the ON/OFF switch.
Switching IREN with lifting point on
1. Use lifting point to attach machine to the safety load hook of the crane.
2. Switch on the machine via the ON/OFF switch of the inverter.
Note:
Please also refer to the operator's manual of the inverter.
Switching IREN ST 1/2 on
1. Use the pipe to hold the machine near the vibrator head.
2. Switch on the machine via the ON/OFF switch.
NOTICE
Electrical voltage.
Incorrect voltage can cause damage on the machine.
f
Check if the voltage of the current source corresponds with the information
of the machine, see chapter
Technical Data
.
WARNING
Electrical voltage.
Danger of electrocution!
f
Only use extension cables for which grounded conductors are connected to
the plug and the coupling (only for machines of class rating I).
Summary of Contents for IREN 38
