Operation
GPi 3200 / 4300
32
wc_tx001239gb.fm
2.15
Starting the Generator (S Models)
Starting
procedure
Follow the procedure below to start the machine.
1. Turn the engine switch
(h)
to the CHOKE position (or the RUN position if the
engine is warm or the ambient temperature is high).
2. Insert the starting key into the key switch
(g)
.
3. Turn the starting key clockwise to the “I” (ON) position, then farther to the
START position. The engine will start.
NOTICE:
To avoid machine damage, do not engage the starter motor continuously
for more than five seconds. If the engine fails to start, return the starting key to the
ON position, wait approximately 10 seconds, and then try again.
Do not turn the key switch to the START position when the engine is running.
4. If you started the engine with the engine switch in the CHOKE position, allow the
engine to run for 20–30 seconds and then turn the engine switch to the RUN
position.
5. Use the LED changeover switch
(n)
to switch to display voltage on the LCD. A
reading of 120V indicates that the generator is operating properly.
Troubleshooting
If the engine does not start after several attempts, repeat the starting procedure
with the engine switch turned to the RUN position.
Try starting the machine manually. See
Starting the Generator (Manual Start
Models).
If the engine still does not start, refer to the
Troubleshooting
chapter.
CAUTION
Personal injury or machine damage hazards. Starting the generator with equipment
attached can damage the generator or the equipment. Unexpected equipment
start-up can cause personal injury.
f
Disconnect all equpment from the generator before starting it.
wc_gr006666
h
n
g
