9 Maintenance
27
100_0202_mt_0012.fm
Replace the exciter oil and check the oil level
1. Tip the machine to the side of the filler boring and support it.
2. Place an appropriate collecting container below the filler boring.
3. Remove dirt accumulation within the range of the filler boring.
4. Unscrew the screw plug from the filler boring and allow the waste oil to drain completely.
5. Tip the machine to the other side and support it.
6. Fill new oil (see chapter
Technical Data
for the exciter oil type and volume) in the filler boring. Use an
appropriate and clean filling container.
7. Place the machine level on the ground.
8. Screw the screw plug with seal ring into the filler boring. The torque setting is 100 Nm.
DANGER
Risk of scalding
Use caution when draining hot oil.
NOTE
Perform oil change and oil level check with warm exciter oil. Machine must not be in use
and be level.
Item
Designation
1
Screw plug for filler boring
NOTE
Lay an impermeable film on the working surface to protect against escaping oil.
NOTE
Collect escaping or overflowing oil and dispose of with the waste oil in an environmentally
friendly manner in accordance with the existing rules and regulations of the legislative
body.
NOTE
Only fill with the prescribed volume of oil.
1
1
Summary of Contents for DPS 1850
Page 34: ......
