Wacker Neuson CRT48-35L, Operator'S Manual

Page: 75 / 116

wc_tx004196gb_FM10.fm
75
CRT48 Troubleshooting
9 Troubleshooting
Problem Cause Remedy
Engine doesn’t start No fuel in tank Add fuel.
Battery connections loose
or corroded Check and clean battery
connections.
Battery charge low Charge or replace battery.
Defective starter Replace starter.
Engine is hard to start. No fuel in tank Add fuel.
Bleed fuel lines.
Battery charge low Charge or replace battery.
Fuel filter clogged Replace fuel filter.
Fuel circuit failure Check fuel lines.
Machine out of balance;
wobbling excessively Trowel arm(s) bent Replace trowel arm(s).
Trowel arm(s) out of
adjustment Adjust trowel arm(s).
Trowel blade(s) bent Replace trowel blade(s).
Poor handling; excessive
free play in steering
mechanism Worn pivot bearings, rod
ends, and/or cylinder
mounts Inspect pivot bearings, rod
ends, and cylinder mounts.
Replace as needed.
Machine does not move Drive belt broken Replace drive belt.
A vacuum exists between
bottom of blades or pans
and surface of concrete Change pitch on blades or
actuate steering system to
break suction.
Key sheared in the gearbox
output shaft Replace damaged key.