Wacker Neuson CRT48-35L, Operator'S Manual

Page: 41 / 116

wc_tx004193gb_FM10.fm
41
CRT48 Operation
4.11 Starting, Steering, Operating, and Stopping the Machine (Kohler)
Requirements
■
Machine is in serviceable condition and has been properly maintained
■
There is fuel in the tank
Starting the
machine Perform the procedure below to start the machine.
1. Sit in the operator’s seat.
2. Turn the starting key (a) clockwise to the ON position.
3. When the glow plug indicator light (b) turns off, turn the key switch to the START
position and hold until the engine starts.
NOTICE: Cranking the engine for more than five seconds can cause starter
damage.
■
If the engine fails to start, release the key switch and wait 10 seconds before
operating the starter again.
■
If the engine still will not start after multiple attempts, see chapter
Troubleshooting .
4. Allow the engine to warm up before operating the machine.
5. Press the throttle pedal to engage the blades.
This procedure continues on the next page.
wc_gr013213
b
a