Wacker Neuson BH23, Operator'S Manual

Page: 28 / 68

8 Transport
28
8 Transport
Performing preparations
1. Switch off the engine.
2. Remove tool.
3. Lean the machine upright against a solid object and secure it to prevent it
from toppling over.
Wacker Neuson recommends to hang the machine on the truck.
4. Let machine cool off.
Emptying the fuel system
Note: The fuel cap has a pressure relief and vacuum valve through which fuel
can escape when it is warm (e.g. in direct sunlight).
The fuel system must be empty during transport in order to prevent fuel from es-
caping through the pressure relief valve.
1. Remove any dirt around the fuel cap.
2. Unscrew and remove fuel cap.
3. Pump the fuel out into a suitable container or tank, e.g. with a suction pump.
4. Position the fuel cap and tighten it.
5. Start the engine and let it idle until the fuel in the carburetor is used up and
the engine stops.
Transporting the machine
1. Lift machine with the supplementary handle.
2. Place the machine on or into a suitable means of transport.
3. Secure the machine against falling over and down or sliding.
Note: Wacker Neuson recommends to use the truck for the transport on the
construction site, refer to chapter
Accessories .
WARNING
Improper handling can result in injury or serious material damage.
f Read and follow all safety instructions of this operator's manual, see chapter
Safety .
WARNING
Danger of fire and explosions by fuel.
Any fuel that escapes can ignite and cause severe burns.
f Lift and move the machine in the upright position.