Wacker Neuson BFS 1350AL, Operator'S Manual

Page: 38 / 58

Operation
T01136GB.fm
38
3. Place an intermediate layer (disc label) under each faceplate when
using bakelite-bonded cutting discs.
4. Attach cutting blade and spring washer on the shaft.
5. Tighten the hexagonal bolt firmly. To do this, apply counter pressu-
re on the spanner surfaces of the cutting shaft.
Note: To assemble cutting disc on right side tighten nut in anti-
clockwise direction (left-handed thread).
To assemble cutting disc on left side tighten nut in clockwise
direction.
6. Fold down the cutting blade guard.
The flange cover must be in place on the protective hood.
7. Connect the water hose.
Starting the machine is only permitted with a water hose connected
and the water supply turned on.
3.7 Disassembling the cutting blade
3.7.1 Proceed as follows for the disassembly of the cutting blade:
1. Raise the cutting disc guard (1) all the way up.
2. Apply parking brake (6), stop engine (23) and stop water supply
(17).
3. Move quick-lift lever (3) to position at the rear.