Wacker Neuson 28Z3, Service Manual

Page: 129 / 264

SHB 28Z3 EN – Edition 2.0 * 28z3s410.fm
4-17
Engine
4.18 Crankcase vent
Venting system by means of a spring-loaded diaphragm C on the valve cover D
➥
If the specified value is exceeded, a connection is opened between the crankcase and
the intake manifold
☞
Unscrew the fastening screws of the cover
☞
Remove cover A , spring B and diaphragm C
☞
Check diaphragm C for cracks and spring B for deformation
➥
If necessary, replace the parts
➥
Defective parts result in inadequate monitoring of the crankcase pressure and
possible damage
☞
Install the parts in reverse order
4.19 Replacing the glow plugs
Removing the glow plugs
☞
Unscrew the fastening screws of valve cover D , see Fig. 27
☞
Remove the valve cover and the gasket
☞
Remove wiring harness E from the glow plugs
➥
To this purpose slacken the nuts on glow plugs F
☞
Unscrew glow plugs F from the cylinder head
Installing the glow plugs
☞
Screw the glow plugs into the cylinder head
➥
Tightening torque: 14.7 – 19.6 Nm (11 – 15 lbs/ft)
☞
Refit the wiring harness and tighten the nuts
☞
Lightly grease and fit the new valve cover gasket
☞
Fit the valve cover and tighten the fastening screws
Fig. 27: Diaphragm valve cover
D
C
B
A
Fig. 28: Replacing the glow plugs
E
F