WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. OCtOber 28, 2016 12:33 PM
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
5
ACCESSORIES
I. Lens Accessory:
Frosted, red, blue, green and amber lens accessories are used to alter the
spectrum and distribution of the light coming out of the fixture.
Installation:
Place the lens in between the fixture and the shroud.
Tighten the thumb screw on the shroud to secure the lens in place.
II. Surface Mount Accessory
The surface mount accessory is used to mount the fixture to a hard
surface like wood or cement or as alternative to the mounting stake.
Installation:
Mount the accessory to a hard surface using No. 10 Philips
head screws that are at least half an inch long. If mounting on concrete
or something similar, first use a plastic anchor sized for No. 10 screws.
If mounting on a soft surface first attach the included spikes.
Create a route underneath the accessory for your wire to travel through.
Lead your wire through the created route and screw your fixture onto
the surface mount accessory.
III. Tree Mount Accessory:
The tree mount accessory is a way for fixtures to be mounted on
the trunk or a branch of a tree while minimizing damage to the tree.
Installation:
Mark the screw hole locations at the point of installation.
Thread one hex nut from flat side of wood screw bolt until end of
threaded. Use a wrench to screw the bolt into the tree until the
unthreaded portion of the bolt meets the surface of the tree.
(Do this for all three bolts.) Place the tree mount bracket onto the bolts
and secure it using additional hex nuts. Attach light fixture and lead wire
through the bracket. Place all wire nuts into the tree mount bracket.
IV. Extension Accessory
Using extension rods and rod joiners, fixtures can be mounted
away from a surface in any desired direction.
Rods come in 5 sizes: 4 inches, 8 inches, 12 inches, 18 inches, and
24 inches. These rods can be connected via either straight or
90 degree rod joiners.
Installation:
Screw in a rod joiner into your mounting accessory.
Screw an extension rod to the other side of the rod joiner.
Continue to use rod joiners and extension rods until the fixture is
in the desired position.
Lens Accessory
No. 10 Tapping Screw
Surface Mount
Accessory
Removable Spike
Tree Mount Bracket
Hexnut
Wood Screw Bolt
90° Rod Joiner
Extension Rod
Rod Joiner
Mounting Accessory
Shroud
INSTALLATION INSTRUCTION
Accent - Color Changing
5011-CC
