![background image](http://html1.mh-extra.com/html/wac-lighting/accent-color-changing/accent-color-changing_installation-instruction_3114186004.webp)
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. OCtOber 28, 2016 12:33 PM
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
4
Step 6: Beam Angle Adjustment:
14. Note the four pre-determined beam angles on the beam angle
changing dial.
15. Remove shroud before adjusting beam angle (See step 7)
16. Use the provided Hex Key to sightly loosen the set screw one or
two turns. Do not remove set screw from the fixture.
CAUtION:
Do not remove set screw from the fixture. It should
only be removed from the fixture for servicing. Consult factory
for service instruction.
17. Hold the fixture body and Rotate the dial until the arrow is
aligned with the desired beam angle. This beam angle may be
one of the pre-determined markings or any number in between.
CAUtION: Keep the arrow marking on the fixture body between
the beam angle range.
18. Tighten the set screw until it stops. Do not over tighten.
19. Install the shroud
Step 7: Shroud Adjustment
20. Loosen the thumb screw on the shroud.
21. Rotate the shroud until it is in the desired position to properly
cut off glare.
22. Retighten the thumb screw to lock the shroud in place.
Shroud
Thumbscrew
INSTALLATION INSTRUCTION
Accent - Color Changing
5011-CC
Beam Angle Dial
Turn dial with
other hand
Hold fixture
Hex Key
10
25
40
60