WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MArCh 2, 2016 12:00 PM
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
3
INSTALLATION INSTRUCTION
Accent
5011 / 5012
Step 3: Installing the Fixture
8. Screw the fixture onto the stake provided, leading the wire from
the fixture through the wire slot in the stake.
9. If desired, bury your wire by digging a small trench. Close the
trench by applying an inward force to both sides of the trench.
Note: For model 5012, wires MUST be buried at least 18”
below the ground per NEC.
10. Repeat steps for other fixtures in the same electrical circuit.
11. Turn the main power supply back on and make sure the fixtures
light up.
Step 4: Aiming the Fixture
12. Tilting: Loosen the joint screw and adjust the head of the fixture
to the desired direction before retightening the screw.
13. Rotating: Loosen the mounting knob and rotate the fixture to
the desired position before retightening the knob.
Step 5: Dimming Adjustment:
14. Use a Phillips head screwdriver to adjust the dimming dial.
15. Rotate until the arrow on the dial is pointed at the desired
wattage. The wattage may be adjusted to the pre-existing tabs
or any value in between.
16. The lower the wattage, the dimmer the fixture will be.
17. Please refer to the yellow tag to determine the size of the
required transformer.
4W
*6.5W
2W
*3.5W
8W
*10.5W
13W
*13.5W
16W
*14.5W
Model: 5011
Model: 5012
*Numbers not printed
on fixture
Joint Screw
Mounting
Knob
Tilting
Rotating
Runs to
the next
fixture
Transformer
