WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MArCh 2, 2016 12:00 PM
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION
Accent
5011 / 5012
Mounting Stake
Qty: 1pcs
Outdoor Rated Wire Nut
Qty: 2pcs
Hex Key
Qty: 1pcs
Adjustable Shroud
Qty: 1pc
MOUNTING ACCESSORIES
Step 1: Determining the location
1. Make sure your main power is off.
2. At the point of installation, mount the stake by placing a piece
of wood on the stake and hammering the wood.
Hammer till the bottom of the ring is flush with the ground.
3. In the case of hard soil, dig a hole and place the stake in so that
the bottom of the ring is flush with the ground.
Fill the rest of the hole with the removed soil and pack it tight
to secure the stake.
4. Screw the fixture onto the stake provided, leading the wire from
the fixture through the wire slot in the stake.
Step 2: Wiring the Fixture
5. Cut the power supply wire from the transformer at the location
of the fixture.
6. Separate the power supply wire into two individual wires by
lightly pulling on each side so that a couple inches is separated.
7. Strip off ½ inch of the insulating material from each wire and
connect one to each of the wires from the fixture using the
outdoor rated direct burial wire nuts provided.
Note: To install multiple fixtures, also connect the power
supply wire of each additional fixture to the connection
described in 7 of the previous fixture.
Hammer
Wood
Mounting Stake
Soil
Transformer
To Next Fixture
Mounting Stake
Fixture Wires
Wire Slot
Accent Lighting Fixture
