WABECO F1200 high speed, Operating Instructions Manual

Page: 47 / 156

47
10. Feed motions of the x, y and z axes
■
The longitudinal motion of the cross slide support (x-axis) is carried out by turning the hand wheel
(12). The skid is secured with the clamping lever (3).
■
The transverse motion of the cross slide support (y-axis) is carried out by turning the hand wheel
(4). The skid is secured with the clamping lever (21).
■
The feed motion of the boring and milling depth (z-axis) is carried out via the hand wheel (20). To
move the milling head using the hand wheel, undo the clamping lever (18) and then clamp again
when you have finished.
There are scale rings fitted to enable you to read off the distances.
One interval on the scale represents a distance of 0.05 mm. One full turn of the hand wheel is the
same as a skid distance
■
Scale ring x-axis (15)
with trapezoidal threaded spindle of 4 mm - with ball screw spindle of 5 mm
■
Scale ring y-axis (5)
with trapezoidal threaded spindle of 4 mm - with ball screw spindle of 5 mm
■
Scale ring z-axis (33)
with trapezoidal threaded spindle of 2 mm - with ball screw spindle of 2.5 mm
Another option for moving the tool spindle is to use the rotation motion of the activation lever (28).
■
After undoing the clamping lever (39), the rotation motion may be executed.
■
One mark on the scale ring (31) represents a distance of 1 mm.
■
Then tighten the clamping lever (39) back up again.
■
The largest distance of the tool spindle is 55 mm.
It is recommended not to select a travel distance that is too big, instead, in the event of a greater
depth, you should use multiple passes to achieve the milling machine depth needed.