WABECO F1200 high speed, Operating Instructions Manual

Page: 140 / 156

140
19. Coolant system (optional)
19.1 Setting up the coolant system
When mounting the coolant system to a WABECO tool cabinet, the appropriate bores are already
present. The tool cabinet ensures a safe base for the milling machine or coolant system.
If the coolant system is secured to another suitable surface, the two through holes must be bored into
the surface by the client. For the positions of the two fixture threaded sockets (thread M8) of the
coolant system, see diagram. The diameter of the through holes in the surface must be at least 9 mm.
19.2 Mounting of the coolant system to the tool cabinet
(optional)
■
The coolant system (2) is positioned, as shown, on the tool cabinet (1).
■
The screws and washers required for assembly are included in the scope of delivery.
To screw the coolant system to the tool cabinet
proceed as follows:
1. Combine each screw with a washer
2. Open the door or the tool cabinet
3. Push the screws from below, through the bored holes in the tool cabinet, into the fixture threaded
sockets and tighten using a Allen key of size 6.