W Box Technologies WBXID134RT, Manual

Page: 8 / 266

8
Make sure that the wall is strong enough to withstand three times the weight of the camera.
NOTE:
For the camera that supports IR, you are required to pay attention to the following precautions to prevent IR reflection:
Dust or grease on the dome cover will cause IR reflection. Please do not remove the dome cover film until the installation
is finished. If there is dust or grease on the dome cover, clean the dome cover with clean soft cloth and isopropyl alcohol.
Make sure that there is no reflective surface too close to the camera lens. The IR light from the camera may reflect back
into the lens causing reflection.
The foam ring around the lens must be seated flush against the inner surface of the bubble to isolate the lens from the IR
LEDS. Fasten the dome cover to camera body so that the foam ring and the dome cover are attached seamlessly.
1. Ceiling Mounting
Steps:
a)
Drill the screw holes on the ceiling according to the drill template.
b) For dome camera, loosen the set screws with a hex key (supplied) to remove the bubble.
c) Fix the mounting base on the ceiling (wall) with screws.
Drill Template
Hole A: for cables routed through the ceiling
screw hole 1: for Mounting Base
1
1
1
A