W & A Delta Plow, Owner'S Manual

Page: 26 / 70

26
308.708.8185 | Info@WAMfgco.com | Rev. 11/20
RETURN TO INDEX
PREPARATION & SET-UP
LEVELING THE IMPLEMENT
Center Frame L/R Leveling (Figure 1)
1 Hitch the Delta Plow to a tractor (page 22).
2 Raise the implement.
3 Adjust the tractor 2-point lift arms so
that the center section tool bar is level.
Wing Leveling (Figure 2 & 3)
1
Remove wing lock pins from the lock position, and
place in the non-locking position before folding
the wings.
2
Check wing for level at the top of the tool bar.
3
Fold implement to access leveling bolts.
4
If wing is too high, tighten bolts in 1/4-1/2” turn
increments, unfolding machine to re-check level. If
wing is too low, loosen bolts in 1/4-1/2” turn incre-
ments, unfolding machine to re-check level.
5 Repeat process until wing is level.
Front-to-Back Leveling
See “Leveling the Machine” on page 35. This
adjustment needs to be completed in field conditions.
Figure 1
Figure 2
Figure 3
Ring Cotter Pin
Wing Lock Pin
CRUSH HAZARD - WARNING
• Keep clear of moving and shifting equipment. Equipment
can move or shift; can result in death or serious injury.
• Hazards may include, but are not limited to, folding wing
movement, raised equipment movement and shifting, etc.
WARNING
LEVEL
LEVEL