25
Steps to Setup PoE Mode
As mentioned above, a PoE switch or PoE injector shall be in use to setup the PoE;
The steps are as below:
1. Mount the camera in an appropriate fixture, e.g. a camera bracket;
2. Plug the M16-8 pin socket end of the Ethernet cable into the M16-8 LAN socket
jack at the back of the camera, and plug the RJ45 end into the Ethernet port of your
PoE switch or PoE injector;
3. Connect the PoE switch or PoE injector to your host processor by Ethernet cable;
4. Connect the PoE switch or PoE injector to power source;
6.1.3 Standalone Mode Installation
This mode is for advanced users who require customization to the software and
application, the applications can run on the processor inside the camera, and output
the result data by either CAN_BUS or EXT_OUTPUT pin. NRE fee shall be charged if
you need Vzense team to do software or application customization.
In this mode, an optional cable (VZENSE-MFP-10P-A) shall be used in this mode.
