VXI VT1433B, User Manual, Page: 185 / 203

Command/Response Protocol
The Command/Response protocol uses the following resources:
q
Command/Query Response register implemented as a general purpose RAM
q
Three parameter registers implemented as a general purpose RAM
q
Additional A24 accessible RAM contiguous with the parameter registers
q
The Command Ready, Query Response Ready, Err* and Done bits of the Status
register.
The RAM registers are the communications media, while the Status register bits
provide synchronization. In general, a controller sends a command to the DSP by
first writing any parameters to the parameter registers and the following RAM
location. It then writes the command to the command register, which clears the
Command/Parameter Ready bit and interrupts the DSP. At this point, the DSP
has exclusive access to the RAM registers. The controller may not access that
RAM again until the Command/Parameter Ready bit is true.
When interrupted, the DSP reads the command and its parameters, writes any
response data back to the Query Response Register and any other data to the
parameter registers and the following RAM and set the Command/Parameter
Ready bit true.
The Query Response Ready bit is used to indicate that the DSP has written query
data to the RAM registers. It is set by the software and cleared by a write of the
Command Register.
The Done bit is set by DSP software when it finishes execution of a command or
a command sequence. This may by long after it has set the Command/Parameter
Ready bit. The DSP software clears the Done bit immediately on receipt of a
new command, before it sets the Command/Parameter Ready bit.
The Err* bit is asserted (to 0) by the DSP software to indicate an error in the
decoding or execution of a command. It is asserted (to 1) if the command was
executed with no error. This bit must be valid before Done is set at the end of a
command.
VT1433B User's Guide
Register Definitions
A-11