6
VUTEC CORPORATION
www.vutec.com
TEL: (954)-545-9006
FAX: (954)-545-9011
EMAIL: [email protected]
02/20/08 – 06/10 Rev. D
2-INSTL_D
WIRING DIAGRAM - 120VAC
WIRING DIAGRAM - 220VAC
The screen may also be operated by optional IR/RF remote control, optional 12VDC trigger relay, optional Low
Voltage control or optional Home Automation control by AMX, Crestron, etc. Consult Vutec for further details.
FIRST OPERATION
CAUTION:
THE
FIRST
CYCLE
DOWN
AND
UP
OF
THE
SCREEN
MUST
BE
PERFORMED
UNDER
CONTROL
OF
AN
ATTENDANT.
THE
MOTOR
LIMIT
SWITCHES
MIGHT
BE
DISENGAGED
DURING
SHIPPING
WHICH
WILL
NOT
STOP
THE
SCREEN
`AUTOMATICALLY
AND
MAY
CAUSE
DAMAGE
TO
THE
SCREEN
IF
IT
IS
ALLOWED
TO
COME
DOWN
BELOW
LEADER
REQUIREMENT.
Verify the leader requirement for the installation. Send the screen down and expect it to stop at the leader
requirement. Stop if the screen appears to go up on the front side of the roller.
If the screen stopped at the leader requirement; send it back up to close the trap door which in turn trips the DCL
switch to stop the motor.
If the screen went below the leader requirement; stop! Send it back up half way, stop! Proceed to
LOWER
LIMIT
ADJUSTMENT
Section for instructions.
CAUTION:
THE
MOTOR
IS
EQUIPPED
WITH
THERMAL
OVERLOAD
PROTECTION
DEVICE.
OPERATING
THE
SCREEN
WITHOUT
ALLOWING
SUFFICIENT
OFF
TIME
COULD
RESULT
IN
THERMAL
OVERLOAD
SHUT
DOWN.
IF
THIS
OCCURS,
SIMPLY
ALLOW
THE
MOTOR
TO
COOL
DOWN
(APPROXIMATELY
15
MINUTES)
BEFORE
RESUMING
NORMAL
OPERATION.
