1
VUTEC CORPORATION
www.vutec.com
TEL: (954)-545-9006
FAX: (954)-545-9011
EMAIL: [email protected]
02/20/08 – 06/10 Rev. D
2-INSTL_D
IMPORTANT SAFETY INSTRUCTIONS
Basic safety precautions should always be followed; including the following:
♠
Read and understand all instructions before proceeding with the installation and operations.
♠
Lectric 2 and Lectric 4 meet requirement for fire-resistant and low smoke-producing
characteristics suitable for operation in a building’s environmental air space, such as above
suspended ceilings, in accordance with Section 300-22 (C) of the national Electric Code,
ANSI/NFPA 70, and sections 2-128, 12-010(3) and 12-100 of the Canadian Electric Code, Part 1,
CSAC22.1.
♠
Be certain that the supporting structure is sound and capable of carrying the weight as required.
♠
Seek qualified electricians to perform electrical requirements.
♠
This permanently connected projection screen must be protected by a fuse or circuit breaker.
Make sure that there is a readily disconnect device incorporated on the building installation
wiring.
♠
Obtain proper lifting mechanism to raise and hold the unit steady for installation.
♠
Plan ahead so the installation can go smoothly and efficiently.
IMPORTANT
WARNINGS
AND
CAUTIONS!
WARNING:
A
WARNING
ALERTS
THE
POSSIBILITY
OF
SERIOUS
INJURY
OR
DEATH
IF
THE
INSTRUCTIONS
ARE
NOT
FOLLOWED.
CAUTION:
A
CAUTION
ALERTS
THE
POSSIBILITY
OF
DAMAGE
OR
DESTRUCTION
OF
EQUIPMENT
IF
THE
INSTRUCTIONS
ARE
NOT
FOLLOWED.
WARNING:
FAILURE
TO
READ,
THOROUGHLY
UNDERSTAND,
AND
FOLLOW
ALL
INSTRUCTIONS
CAN
RESULT
IN
SERIOUS
PERSONAL
INJURY,
DAMAGE
TO
EQUIPMENT,
OR
VOIDING
OF
FACTORY
WARRANTY!
IT
IS
THE
INSTALLER’S
RESPONSIBILITY
TO
MAKE
SURE
ALL
COMPONENTS
ARE
PROPERLY
ASSEMBLED
AND
INSTALLED
USING
THE
INSTRUCTIONS
PROVIDED.
WARNING:
FAILURE
TO
INSTALL
ELECTRICAL
REQUIREMENTS
ACCORDING
TO
NATIONAL/LOCAL
ELECTRICAL
CODES
AND
REGULATIONS
MAY
CAUSE
PREMATURE
FAILURE,
FIRE
HAZARD,
ELECTRICAL
SHOCK,
UNSAFE
PRACTICE
AND
REVOCATION
OF
USE.
DISCLAIMER
Vutec Corporation intends to make this manual accurate and complete. However, Vutec makes no claim that the
information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency
in connection with the installation for use of this product. The information contained in this document is subject to change
without notice. Vutec makes no representation of warranty, expressed or implied, regarding the information contained
herein. Vutec assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this
document.
PRE- INSTALLATION
1)
Carefully cut and remove packing materials.
2)
Carefully unpack and inspect the unit for sign of damages.
3)
Be sure to recheck and measure all pertinent dimensions before installation.
4)
Most basic tools are required for installation.
SAVE THESE INSTRUCTIONS
