2.
Remove washer nut securing switch to front
panel.
Fig. 7
3.
Remove FRONT PANEL from broiler.
4.
Note wire locations then disconnect wires from
switch being replaced.
Fig. 8
5.
Reverse procedure to install.
6.
Check for proper operation.
RACK SPRINGS
NOTE:
Springs should be replaced in pairs for proper
operation of the rack lift assembly.
1.
Remove crumb tray to access tension
adjustment nuts from the front of broiler.
2.
Raise the rack lift assembly to its highest position
on stop plate to relieve spring tension.
3.
Loosen nuts to remove any remaining tension on
springs.
4.
Access the bottom of broiler and remove springs
from the lower arm casting and eye bolt.
Fig. 9
5.
Reverse procedure to install.
6.
Perform RACK SPRING TENSION
ADJUSTMENT.
HEATING ELEMENTS
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove crumb tray from broiler.
2.
Adjust rack assembly to the center position.
3.
Pull rack assembly out and access the rack stops
on the left and right sides of the rack assembly.
Allow enough clearance at the rear of rack
assembly to rotate the rack stops to a horizontal
position. If the rack assembly is pulled all the way
out the rack assembly will engage the rack stops
and prevent removal.
SALAMANDER ELECTRIC BROILER - REMOVAL AND REPLACEMENT OF PARTS
Page 7 of 14
F45545 (0315)