10
Connecting the wireless speaker to a computer
Your DECT dongle is preregistered to the wireless speaker.
To connect the wireless speaker to your computer:
1. Plug the dongle in the USB port on your computer.
The dongle LED light will turn steady green.
2. Press the
key on the wireless speaker.
This enables the speaker to play audio.
Registering the dongle
Your DECT Dongle is preregistered to the wireless speaker. You do not need to
register your dongle. However, the steps below are provided in the event you
need to manually deregister and re-register your dongle.
To register the dongle to the wireless speaker:
1. Make sure the wireless speakerphone is properly installed. Flashing red and
green LEDs indicate the wireless speaker is ready for registration.
2. Press and hold the REGISTRATION button on the bottom of the wireless
speaker for five seconds, and then release the button.
3. Plug the dongle to the computer.
4. Press and hold the LED status button on the dongle for about four seconds
until the Dongle LED light flashes red very quickly, and then release the
button.
It takes about 60 seconds to complete the registration process. Once the wireless
speaker is registered, the wireless speaker LEDs stop flashing. The LEDs turn
green briefly and then turn off.
Deregistering the dongle
1. Press the key on the dongle for 10 seconds to enter deregistration mode.
After 4 seconds the red LED starts to double-flash; after 10 seconds the
LED starts to flash red rapidly, indicating that the dongle has entered
deregistration mode.
2.
Release the key and press it again for 1 second to confirm deregistration.
The LED turns green for three seconds, turns off for one second and then
shows steady red light.