16
PB
Appendix
Troubleshooting (continued)
The battery does not charge in the parent unit or the
parent unit battery does not accept charge.
Make sure the battery s nstalled n the parent unt battery
compartment correctly. The
LINK lght on the parent unt should be
on.
Completely remove and nstall the battery agan, then charge for up
to 11 hours.
If
LINK lght on the parent unt s not on, refer to The LINK
light on
the parent unit is off below.
If the
battery s completely depleted, t may take up to 30 mnutes
to charge the parent unt before t can be used for a very short tme
(page 6).
Purchase a new battery. Refer to
Parent unit battery installation
(page 3) and
Parent unit battery charging (page 6).
The LINK light on the parent unit is off.
Make sure the parent unt battery s nstalled (page 3) and charged
(page 6) correctly.
Make sure the power adapter and the parent unt are plugged n
correctly and securely.
Unplug the parent unt power adapter. Wat for 15 seconds before
pluggng t back n. Allow up to one mnute for the baby unt and
parent unt to reset.
The parent unit beeps and is not performing normally.
Make sure the baby unt s turned on.
Move the parent unt closer to the baby unt (but not less than
1 metre). The parent unt may be out of range.
If the parent unt s powered by the provded battery pack, t may not
have enough charge for the parent unt to perform normally. Charge
the battery n the parent unt for up to 11 hours.
Reset the parent unt and the baby unt by turnng them off and
unpluggng the electrcal power to the parent unt and the baby
unt. Wat for 15 seconds and plug them back n agan. Turn on the
parent unt and the baby unt. Allow up to one mnute for the parent
unt and the baby unt to synchronze.
•
•
•
•
•
•
•
•
•
•
•
•