VST easyDAB+5, User Manual

Page: 16 / 40

VST 5 User Guide
13
MENU SETTINGS
You must press the Rotary Knob then MENU button to enter the menu function, rotate the
Rotary Knob [
◄
] [
►
] to select a menu setting, and then press the Rotary Knob to confirm the
selection.
To Enable AFC (Automatic Frequency Change) or AutoScan Mode
By default 5 is already set to use AFC_H mode; however, if you want to change the
operating mode, do the following:
1.
In the menu function, rotate the Rotary Knob [
◄
] [
►
] until the screen shows
《
LINKMODE
》
, then press Rotary Knob to enter the selection operation.
2. Rotate the Rotary Knob [
◄
] [
►
] until the screen shows
《
AFC_H
》
or
《
AFC_L
》
or
《
AUTOSCAN
》
, then press Rotary Knob to enable .
ATTENTION
The 5 comes with the AFC function. In order to use this function, your car radio
must have AF (alternative frequency) feature, and AF must be enabled. Please consult your
car radio manual or the car dealer for these requirements before using this function.
While working with the AFC function, the possible factors that could affect its normal
operation are:
1. The FM sensitivity varies among car radios and the sensitivity can affect AFC’s
performance.
2. The algorithm implemented in each car radio’s AF feature varies and this can affect
radio’s FM frequency tuning when triggered by AFC.
If AFC function is unable to function normally, please enable and use AutoScan mode instead.
To Enable DLS/DL+ Display
1. In the menu function, rotate the Rotary Knob [
◄
] [
►
] until the screen shows
《
RADIOTXT
》
,
then press Rotary Knob to enter the selection operation.
2. Rotate the Rotary Knob [
◄
] [
►
] until the screen shows
《
ON
》
or
《
OFF
》
, then press
the Rotary Knob to set the DLS/DL+ display on or off.
To Enable RC Beep Tone
When you enable RC beep tone, 5 will respond with a beep tone, each time an
operation is performed on the remote control.
1.
In the menu function, rotate the Rotary Knob [ ◄ ] [ ► ] until the screen shows
《
RC BEEP
》
,
then press Rotary Knob to enter the selection operation.
2. Rotate the Rotary Knob [
◄
] [
►
] until the screen shows
《
BEEP ON
》
to enable, or