![Vroom GF-120 Installation And Operating Instructions Manual Download Page 9](http://html.mh-extra.com/html/vroom/gf-120/gf-120_installation-and-operating-instructions-manual_1052735009.webp)
9
CONNECTING AND DISCONNECTING THE HOSE
1. Lift the inlet valve cover on the front of the door.
2. Insert the hose end (with the shorter hose cuff) into the valve with
a twist and a firm push to secure (see photo at right).
3. To remove, turn hose in either direction while pulling hose
towards you.
TIP:
If you break off the hose inlet valve cover, simply reattach
it by lining up one of the small dimples located on the inside
of the inlet cover and then press hard on the other side to
click into position.
ON / OFF SWITCH
1.
To start the vacuum, push the switch to the “I” position.
2.
To stop the vacuum, push the switch to the “O” position.
NOTE: The lower part of the vacuum will be warm when in use.
CHANGING THE FILTRATION BAG*
(see photos below)
NOTE: NEVER RUN VACUUM WITHOUT A FILTRATION BAG OR FILTERS IN PLACE
1. Open the door on the vacuum by pushing the latch upward and remove both door and bag.
2. Carry door and filtration bag to the trash container. Remove full bag and discard.
3. Place a new filtration bag all the way over the scoop (A),
tight against the door
(B).
4. When closing door, tuck in the top part of the bag, so the door is properly sealed and the
latch clicks into place (C).
DO NOT REUSE BAGS
–
the pores in the bag will clog after the bag is filled the first time.
Operating Your Vroom Garage Vac
A. Slide the collar of the
dust bag over the
B. Push the cardboard collar of
C. Push the top edge of the bag in-
CHANGING THE MOTOR FILTER*
1. Remove door and filtration bag.
2. Reach into the cavity (below the bag when installed) and
remove the motor filter.
3. If filter is dirty, clean it with a vacuum or wash in mild soap
by hand.
Do not put in washing machine.
Let the filter
dry
completely
before installing in the vacuum.
4. Replace the motor filter and tuck in the corners and all 4
sides carefully under the vertical ribs so that the filter lays
flat on the grid (see Figure C). Ensure that the front side
(which you cannot see) is under the ribs.
Figure C
Door
Latch
Motor
Filter
* If Replacement bags and filters are needed, please order #Y08-5, which includes 5 bags,
1 motor filter and 1 exhaust filter (see next page for replacing the exhaust filter).
Summary of Contents for GF-120
Page 12: ...12 IH 137 ...