Vroom GF-120, Installation And Operating Instructions Manual

Page: 5 / 12

5
Mounting Instructions for Vroom Garage Vac Model GH-120
Surface Mounting to Drywall Surfaces (1/2″, 13mm, thick)
1. For maximum coverage, choose a wall or surface that is located close to the garage door
and has an electrical outlet close by.
2. Use the paper template from the back page of this instruction manual, and tape to the wall or
surface. Vroom Garage Vac must be installed a minimum
of 3″ (75mm) from the floor for the
exhausting air. Align the template so that the 2 vertical center points of the template are
aligned over the centerline of a 2x4 stud behind the drywall for additional stability. Use a
level for alignment.
3. With an awl or similar pointed object, mark the center of the key holes accurately. Carefully
remove template from the wall and place with this manual for future reference.
4. Using a 3/32 drill bit, pre-drill all 4 holes.
5. Using a 5/16 drill bit to enlarge
only the
2 holes which go through the drywall
without the stud support. These are the
holes that require 2 drywall anchors.
6. Squeeze the two arms of the plastic
anchor together and insert through the
hole. Very lightly hammer the anchor
flush with the drywall surface.
7. Insert the red key-pin and push firmly
to toggle the anchor open behind the
drywall. Remove red pin.
8. Attach all four #8 screws through the
marked keyholes. Keep the screw
heads 1/8″ from the wall surface.
Follow steps 4 - 7 from Page 4 to
complete installation.
•
For wood surface use the
2 screws supplied with
the wand holder package.
•
For dry-wall use two 1-1/2 long
screws from the fastener package.
NOTE: The wand holder should be
mounted against a wall stud for extra
strength.
Wand Holder Installation
MODEL GH-120
DIMENSIONS & FEATURES
(Surface Mounted with Electric Cord)
DOOR
(to access
filter bag and
motor filter)
INLET VALVE
COVER
(lift cover &
insert hose
here to use)
DOOR
LATCH
(push latch
upward to
open)
HOSE
RETAINER
(holds 8
-
to-40 ′
stretch hose
neatly in place)
2-PIECE
UPHOLSTERY
TOOL
DASHBOARD /
DUSTING
BRUSH
CREVICE
TOOL
FLEXIBLE
CREVICE
TOOL
ADJUSTABLE WAND, FLOOR BRUSH, WAND HOLDER
AND 40 ′ STRETCH HOSE INCLUDED BUT NOT SHOWN
BUILT-IN
TOOL CADDY
ON / OFF
SWITCH
EXHAUSTING AIR
(location of exhaust filter)