7
Mounting Instructions for Vroom Garage Vac Model GF-120
GROUNDING INSTRUCTIONS for GF-120 WHEN PERMANENTLY WIRED
This appliance must be connected to a grounded metal, permanent wiring system; or an
equipment-grounding conductor must be run with the circuit conductors and connected to
the equipment-grounding terminal or lead on the appliance.
WARNING
: Disconnect all electrical power to the wall area before installing. Do not drill near
studs where electrical cable may be secured to studs adjacent to receptacles.
NOTE
: The 4 mounting holes in the outer corners of the flange of the Vroom Garage Vac must
be drilled from the back of the unit with a 3/16″ (4.5mm) drill bit when the unit is to be recessed
into a wall. To reach with the vacuum hose as far as possible, choose a wall or surface that is
centrally located and has an electrical outlet or switch from a 16 amp circuit breaker. Make
sure the wall is hollow and there are no pipes or other obstructions in the section you choose.
TIP
: Find a place that is close to the garage door so that you can clean your car in the drive
way as well as inside the garage. After you cut the hole for the Vroom Garage Vac you may
prefer to paint the back wall inside the opening with a color matching the Vroom Garage Vac.
MODEL GF-120 DIMENSIONS & FEATURES
(Flush Mounted & Hard Wired)
2-PIECE
UPHOLSTERY
TOOL
DASHBOARD / DUSTING
BRUSH
CREVICE
TOOL
FLEXIBLE
CREVICE
TOOL
ADJUSTABLE WAND, FLOOR BRUSH, WAND HOLDER
AND 40
′
STRETCH HOSE INCLUDED BUT NOT SHOWN
HOSE
RETAINER
(holds 8
-
to-40
′
stretch
hose neatly in place)
DOOR
(to access filter bag
and motor filter)
INLET VALVE COVER
(lift cover & insert hose
here to use)
DOOR LATCH
(push latch
upward to open)
BUILT-IN
TOOL CADDY
BUILT-IN
HOSE HOLDER
ON / OFF
SWITCH
EXHAUSTING AIR
(location of exhaust filter)
Summary of Contents for GF-120
Page 12: ...12 IH 137 ...
