Cut away only
the film both side
A B
Carefully slide the stabilizers onto the fuselage, ensuring that they are accurately aligned, Allowing
the excess epoxy run out. Clean off the excess epoxy.
When you are satisfied with the alignment, use a pencil to carefully trace around the left and
right of the Vertical stabilizer where them meet the fuselage. Note, it is important not to disturb
the alignment of the stabilizer.
Remove the vertical stabilizer from the fuselage. Using a sharp hobby knife, cut away the
covering inside the lines. Not to cut into the wood.
Spread epoxy onto the left and right of the vertical stabilizer.
Note: When joining the stabilizer it is
extremely important to use plenty of
epoxy (30 minutes)
14-
Vertical Stabilizers installation
A = A’
B = B’
A
A’
90
O
90
O
B
B’
A B
Cut away only
the film both
side
Cut away only
the film both side
A B
Carefully slide the stabilizers onto the fuselage, ensuring that they are accurately aligned, Allowing
the excess epoxy run out. Clean off the excess epoxy.
When you are satisfied with the alignment, use a pencil to carefully trace around the top and
bottom of the Horizontal stabilizer, right and left of the Vertical stabilizer where them meet the
fuselage. Note, it is important not to disturb the alignment of the stabilizer.
Remove the horizontal stabilizer from the fuselage. Using a sharp hobby knife, cut away the
covering inside the lines. Not to cut into the wood. Spread epoxy onto the top and bottom of
the horizontal stabilizer.
Note: When joining the stabilizer it is
extremely important to use plenty of
epoxy (30 minutes)
A = A’
B = B’
A
A’
90
O
90
O
B
B’
IMPORTANT:
Please do not clean off the excess epoxy on the wing with strong solvent or pure alcohol, only use kerosene to keep
the colour of your model not fade.
Spread epoxy on top
and bottom
Spread epoxy onto
left and right side.
13-
Horizontal Stabilizers installation