Slide the nose gear push rod through the nose gear control horn.
With the screw hole facing forward, slide the nose gear control horn onto
the straight end of the nose gear so the so the steering arm extends in the
opposite direction of the nose gear axle.
Rotate the nose wheel back and forth a few times to make sure it rotates
freely with out any binding.
Securely attach the nose gear mount to the
fire wall using the four 3x20mm(1/8X51/64”) screws.
A B
9
-
Nose Gear / Bugfahrwerk
Slide the wheel onto the nose landing gear axles and secure it with the
supplied wheel collars.
.....................4
Blind-nut
............4
3x20mm screw
....................1
1/8x51/64”
NOSE WHEEL
NOSE WHEEL ARM
NOSE WHEEL
PUSHROD
FIRE-WALL
TOP-VIEW
X
To muffler
Filler tube
To engine
1/8x1-13/32”(3x35mm) screw
Rubber stopper
5/32”(4mm)
10-
Fuel Tank Installation
Ensure that the fuel tank clunk does not touch the rear of the fuel tank.
Checking for leaks - block the vents and blow into the
feed - if in doubt submersing the tank in a blow of
water will show up any problems.
Blow
Water
2
After confirming the direction . Insert this assembly, clunk end
first, into the fuel tank and tighten and screw the fuel tank cap on
firmly.
Carefully install the fuel tank
to ensure that they will not
shift during flight (secure the
fuel tank in place using foam
padding).
1
3
To rudder servo