APSPS1_RevA_1/19
10
Remote Control Operation
This system is only compatible with the Prestige two (2) button 1-Way remote controls. The matrix below describes how
the remote control will operate the basic system functions. See Owner's Guide for more detailed information
ARM
DISARM
Bu
�
on
Ac
�
on
Func
�
on
Press 1x
Lock
Hold 3 Seconds
Panic ON
Unlock
Panic OFF
AUX Ch. 3
Press 1x
Hold 3 Seconds
ARM DISARM
ARM
DISARM
Quick Reference:
System Operation and Programming
Ignition Off
1 Chirp = Bank 1
(Program Remotes)
Cycle Key ON 5X
To Enter Programming
Chirps Indicate
Option Number
... or Exit
Programming
Press to Change
Feature
LED Indicates
Feature Selection
Note:
Programming will time out after 60sec with no activity or Ignition Off for 5sec.
5X
Repeat Steps to Program
Another Feature ...
Cycle Key OFF/ON
To Move Enter Bank 2
Press to Change
Option
1X
2 Chirp = Bank 2
(Feature Programming)
ARM
DISARM
LO
CK
A
CC
ON ST
AR
T
LO
CK
A
CC
ON ST
AR
T
LO
CK
A
CC
ON ST
AR
T
Once the system is installed and powered up, you will use the vehicle ignition and a programmed remote control to set
all system options. Feature options are divided into categories, or
Banks
, as described throughout this section.
Ensure
that at least one remote control is programmed
to the system. If not, or if you need to program more remote controls,
use the diagram steps to access
Bank 1.
The siren and LED will indicate your status and selections. Follow the diagram
below to enter and maneuver through the programming procedure.
Programming Mode Entry and Exit Procedure
1. Cycle the ignition ON 5X ending in the ON position.
2. The system will beep (1) one time, indicating you have accessed Feature Bank 1, Remote Programing.
3. Cycle the ignition OFF/ON.
4. The system will beep (2) two times, Indicating you have accessed Feature Bank 2, Feature Programming.
5. Once you have accessed the desired bank, press the ARM button on the remote control to advance through the
features. The LED will flash a number of times to indicate the feature, based on the charts that follow this section.
The system will chip a number of times to indicate the Option programmed.
6. Once you have accessed the desired feature, press the DISARM button on the remote control to advance through the
feature's setting options. The system will beep a number of times to indicate the Option setting, based on the charts
that follow this section.
7. Once you have made the desired setting, you can press the ARM button on the remote control to advance through
the features within the bank.
8. Once you have completed programming,
you MUST turn the ignition key to OFF
to exit the programming
mode. Programming will automatically exit after 60sec of inactivity.
