VOX electronics WM1065-SYTQD, Operating Instructions Manual

Page: 25 / 154

EN - 21
7.3 Pump Filter
1
3
5
2
4
6
The pump filter system in your Washing
Machine prolongs the life of the pump by
preventing lint from entering your machine.
We recommend that you clean the pump
filter every 2 months.
The pump filter is located behind the cover
on the front-lower right corner.
To clean the pump filter:
1.
You may use the washing powder spade
(*) supplied with your machine or liquid
detergent level plate to open the pump
cover.
2. Lodge the end of the powder spade
or liquid detergent level plate in the
opening of the cover and gently press
backwards. The cover will open.
• Before opening the filter cover, place a
container under the filter cover to collect
any water left in the machine.
• Loosen the filter by turning anticlockwise
and remove by pulling. Wait for the
water to drain.
NOTE:
Depending on the
amount of water inside the machine, you
may have to empty the water collection
container a few times.
3. Remove any foreign materials from the
filter with a soft brush.
4.
After cleaning, re-fit the filter by inserting
it and turning clockwise.
5. When closing the pump cover, ensure
that the mountings inside the cover
meet the holes on the front panel side.
6. Close the filter cover.
WARNING:
The water in the
pump may be hot, wait until it has cooled
down before carrying out any cleaning or
maintenance.
(*) Specifications may vary depending on
the machine purchased.
7.4 Detergent Drawer
The use of detergent may cause residual
build up in the detergent drawer over time.
We recommend that you remove the drawer
every 2 months to clean the accumulated
residue.
To remove the detergent drawer:
• Pull the drawer forwards until it is fully
extended.
• Press the region shown below inside
the detergent drawer you have pulled
all the way back, and continue pulling
and remove the detergent drawer from
its place
• Remove the detergent drawer and
disassemble the flush stopper. Clean
thoroughly to completely remove any
softener residue. Refit the flush stopper
after cleaning and check that it is seated
properly.