- 3 -
Water Pump:
The pump key switches the pump relay on or off. The state of the relay is indicated by the
adjacent LED. Operation of the pump is only possible, if the main switch had been switched-on.
It will be switched-off automatically, as soon as the main switch had been switched-off. The
pump cannot be switched-on, if the main switch had been switched-off.
Solar Computer:
The Solar Computer indicates the current operating state, the solar current, as well as the
solar power of the connected VOTRONIC Solar Controller. In addition, it is equipped with a
solar power meter.
Use the arrow keys on the right side of the display to change to the next or previous
page.
Current:
The instantaneous current rate in Amperes (A) is displayed.
Capacity:
The instantaneous capacity in Watts (W) of the solar system is displayed.
Solar Power Meter:
The power being generated by the solar system is measured
continuously and will be displayed as ampere-hours (Ah), as well as watt-hours (Wh). If the
value 9999 Wh is exceeded, the display changes automatically to kWh. The meter readings
can be separately reset to zero at any time. Reset can be effected, if the corresponding
meter value is displayed and by pressing the key Solar for more than 3 seconds until (Set
----) is displayed.
Operating State Solar Controller:
Depending on the solar controller, the operating state of the solar controller is indicated by
the sun symbol.
-
No sun: Solar power is not at disposal; the solar controller is in stand-by mode.
-
Full sun: Solar power is at disposal, maximum possible charge
-
Flashing sun: The controller limits the current because of a full or almost full battery to
avoid battery overcharging. For determination of the possible solar power, the battery
must be discharged by a consumer (such as lighting) until the solar controller stops
limiting the current and the sun symbol stops flashing.
Thermometer/Clock:
The thermometers indicate the inside and outside temperature.
Press the key "Thermometer/Clock" to change between inside and outside temperature or
clock.
The time is displayed in 24 hours format.
Setting of the time is effected by pressing the key "Thermometer/Clock" for 3 seconds,
until "Set" will be displayed at the upper edge of the display, and the hours of the time will
be flashing. Use the arrow keys
to set the hours. Shortly press the key
"Thermometer/Clock" to set the minutes. The minutes will now be flashing and can be
changed using the arrow keys .
Tank Displays:
The tank displays indicate the levels (level height) of the fresh water and sewage water
tank as percentage.
Use the key "Tank" to switch between the display for fresh water tank and sewage water
tank. If the sensors had not been connected or are wrongly connected, the corresponding
tank display cannot be selected.
Current will only be supplied to the tank sensors, if the levels will be interrogated by a
keystroke. If the illumination of the display is switched-off manually, or if it switches-off
itself after a certain time, the display changes automatically to the actual time. Thus, an
unintended operation of the sensors and current consumption is avoided.
Summary of Contents for VPC Jupiter 100
Page 10: ... 10 Notes ...