- 2 -
Start-up:
Always disconnect the power supply to the battery prior to working on the electric system to avoid
short-circuits!
The Info Panel Pro is connected prior to the final installation. Therefore, the length of the connection cable should be
sufficient, in order to facilitate connection and installation of the display unit. It is, however, recommendable to use
connection cables of different colours to avoid malfunctions due to mixed up connections.
The connections of the panel are combined on the terminal strip, and they are marked on the on the board by numbers.
The numbering of all VOTRONIC units has been assigned systematically to the corresponding connections, and they are
explained by a label on the rear side. Thus, the configuration of connections is always available.
It doesn't make any difference if the connections are plug-in type terminal screws or female connectors.
It is
IMPORTANT
to carefully screwing down and crimping the stripped cable with all single wires, observing
that no single wires jut out laterally!
When inserting brand-new female connectors for the first time, expenditure of force is required.
We therefore recommend to carefully using pliers for the first insertion.
Switch Functions:
Main Switch:
This switch is used to switch the entire power supply in the camper on or off. It is indicated by the red light-emitting diode
“Main Switch”.
The switch is designed for small to medium-sized systems, which means, that the maximum switching current of the board
supply should not exceed approx. 16 A.
In case of higher current load due to consumers, switching by a VOTRONIC Battery Protector is recommendable, see page 3,
“Automatic Protection against Total Discharge and Remote-controlled Main Switch”.
Operation:
If the main switch is actuated, all displays will be started for a short moment for reasons of testing, and all signal LEDs on
the display will be lighting up.
After that the unit will change to normal operation. The board battery, the fresh water and the sewage water tank will be
displayed, and usual operation is allowed. 10 minutes after the last activity, the display will be switched-off automatically
for reasons of power saving.
Pump (Pump Main Switch):
This switch is used to switch-on the pump of the water supply, which is indicated by the red LED “Pump".
Any commercially available pump, the current consumption of which does not exceed approx. 10 A, can be connected.
