Assembly instructions VOSSOBW501
SG sensor
, Page 17 of 22
Step 10
Apply the adhesive and sealing compound underneath the
end of the sensor and underneath the cable.
Do not fix and fill up the corrugated tube with the
adhesive and sealing compound to ensure that water
could drain later in operation.
Fig. 34: Applying the adhesive and sealing compound
underneath the cable
Step 11
Completely fill up the protection cover, including shoulders,
with the adhesive and sealing compound.
Avoid air bubbles, if possible. Hold the nozzle inside
the adhesive and sealing compound during filling.
Nozzle can be shortened with knife to make it easier
and faster to fill up the protection cover with the
adhesive and sealing compound
Fig. 35: Filled up cover
Step 12
Carefully put the cover over the sensor.
Distance between surface and cover can vary from 2-5
mm. Do not try to push it completely to the surface.
Make sure that no adhesive and sealing compound
reaches the corrugated tube to ensure that water
could drain later in operation.
Fig. 36: Fixing the cover
!
!
!
!