Assembly instructions VOSSOBW501
SG sensor
, Page 15 of 22
Step 5
Before applying the adhesive do a final cleaning of the
sensor installation surfaces with cleaning solvent and lint-fee
cloth as a precaution.
Apply the adhesive to the sensor.
Apply enough adhesive to only one area, so that it can
spread over the surface from there. Do not distribute it
with mixer tip.
When adhesive bonding, temperature of the axle
should be above +10 °C (+50 °F).
Fig. 29: Applying the adhesive
Step 6
Immediately after applying the adhesive, attach the sensor to
the prepared surface, and apply pressure with your thumb
for a minimum of 5 minutes @+20 °C (+68 °F).
The assembly takes place with the main deformation
direction with 0 ° or 180 °.
Fig. 30: Attaching the sensor
Step 7
Finally, carefully align the cable and fix the cable ties to
avoid mechanical stress to the sensor.
Do not apply pressure to sensor.
Fig. 31: Aligning the cables and fixing the cable ties
!
!
!
!