VOSS.farming easyCUT go, Instruction Manual

Page: 29 / 124

DE
EN
FR
IT
NL
SV
ES
PL
29
85340 | 02 | 2021 | V2
INSTRUCTION MANUAL VOSS.FARMING EASYCUT GO
EN
Motor
Problem Cause Solution
Motor is very
loud
Bearing seized Contact the service department.
Motor runs
very slowly
1. Battery almost empty
2. Carbon brushes worn
out
3. Rotor or stator
defective
1. Change and charge the battery as
described in sections 7.4 and 9.1.
2. Contact the service department.
3. Contact the service department.
Shaving head/blade
Problem Cause Solution
Upper blade
does not move Defective reduction drive
Contact the service department.
Upper blade
does not
move over the
entire running
surface
1. Eccentric worn out
2. Eccentric shaft
defective
Contact the service department.
Shaving head
gets very hot
1. Blade tension is too
high
2. Blades or head run dry
1. Adjust the tension of the blades with
the tensioning nut. If this solves the
problem and the device does not cut,
the blades must be sharpened.
2. Oil the blades/head.
Blades do not
cut
1. Eccentric defective
2. Primary reduction
gearing defective
3. Shaving head worn out
Contact the service department.
Blades cut
badly
1. Blade tension is too low
2. Blades have rust
3. Shearing blades are
blunt or not sharpened
properly
1. Increase the tension of the clipper
blades with the tensioning nut.
2. Have the clipper blades resharpened
at a specialist shop. If there is too
much rust, replace the blades with
new ones.
3. Have the clipper blades resharpened
by a specialist.