Vortice CA 100 MD, Instruction Booklet

Page: 10 / 84

• Do not make changes of any kind to the unit.
• Do not leave the device exposed to adverse weather
conditions (rain, sun, etc.).
• Do not rest objects on the device.
• Periodically check device conditions. If imperfections
are noted, do not use the unit and immediately
contact a Vortice authorised Technical Assistance
Centre.
• Promptly contact a Vortice authorised Assistance
Centre in the event of unit malfunction and/or failure
and request the use of original Vortice spare parts
for any repairs.
• If the unit falls or receives a strong blow, immediately
have it inspected at a Vortice authorised Technical
Assistance Centre.
• Only connect the device to the mains supply/
electrical outlet if plant/outlet capacity is suitable for
its maximum power. If otherwise, immediately seek
assistance from a professionally qualified person.
• Switch off the main switch on the system when: a) a
malfunction is detected, b) you decide to perform
external cleaning maintenance, c) when you decide
not to use the device for prolonged periods.
• It is essential to ensure that sufficient air re-enters
the room, in order to guarantee product operation. If
a combustion-powered, non air-tight device is
installed in the room (water heater, methane stove,
etc.), please ensure that air re-entry also guarantees
the perfect combustion of said device.
• The unit cannot be used as an activator for water
heaters, stoves, etc. nor should it discharge into hot
air ducts.
• The device must discharge in a single duct (used by
this product only), or directly outside.
• Never cover the two intake grilles and the device
return duct, to ensure optimal air passage.
• The product delivery point must always be
connected to a duct.
• Maximum room temperature for unit operation is
50°C.
• The electrical specifications correspond to the ones
on the data label A (fig.A).
•
An omnipolar switch with a
contact opening distance of 3
mm or higher should be
provided
for installation,
enabling complete
disconnection under overvoltage
category III conditions.
•
Products equipped with single-
phase wiring (M) engines
ALWAYS require connection to
220-240V (or only 230V where
required) single-phase lines. Any
kind of modification shall be
considered
as product
tampering and shall nullify the
relative warranty.
•
No specific adjustment is
necessary as the devices
operate at nominal frequencies
without a preliminary setting.
• Thermal protection devices:
- Manual reset thermal protector
The following models are equipped with a manual
reset thermal protector
If the thermal protector is triggered, please contact
qualified personnel or Vortice authorised
Technical Assistance Centre.
If the problem persists after the reset
operation, check the electrical system to which the
unit is connected. In this case, please contact a
Vortice authorised Technical Assistance Centre or
professionally qualified personnel.
Typical applications
See Figures 1-5;
The images shown refer to typical applications for this
product.
In particular, in Figure 5, it is possible to check the
correct orientation of the product from duct:
A = intake
B = delivery
IMPORTANT
The product delivery point must always be connected
to a duct for correct operation.
10
ENgLISH
Caution:
this symbol indicates that care must
be taken to avoid damaging the appliance
!