Vortice 8010300112640, Instruction Booklet

Page: 55 / 88

55
LL TP HCS
Factory settings
- switch-off delay (dip switch): 6 min
- switch-on delay (dip switch): 45 seconds
- humidity threshold: 70 %RH
- operation mode: Timer
- 2 speeds: position A of the jumper (fig.16)
Possible settings
- Jumper setting (fig 15b,16). The motor has two operating speeds: V1 and V2. By appropriately setting the
jumpers as described in the following table A it is possible to determine which will be the maximum and
minimum speed between V1 and V2. The timer will always act on V1.
- Dip-switch settings (fig. 17). N.B. Before making any changes to the dip-switches, disconnect the electric
power supply. It is possible to configure the time lag for switching on/off, and the Relative Humidity threshold
value (see under Use), by appropriately setting the 6 dip-switches as described in the following tables:
T
A
= time lag for switching on
T
B
= time lag for switching off
T
C = automatic cycle time
U
R = relative humidity
ENGLISH
DIP switch
Int. 1 Int. 2 Int. 3 Int. 4 Int. 5 Int. 6
T
A
0 sec. OFF -- -- -- -- --
45 sec. ON -- -- -- -- --
T
B
6 min. -- OFF OFF -- -- --
12 min. -- OFF ON -- -- --
18 min. -- ON OFF -- -- --
24 min. -- ON ON -- -- --
U
R
70% -- -- -- OFF OFF --
90% -- -- -- OFF ON --
80% -- -- -- ON OFF --
60% -- -- -- ON ON --
Operat.
mode
Timer -- -- -- -- -- OFF
Disabl. HCS -- -- -- -- -- ON