EXCLUSION OF LIABILITY
Any use that differs from or goes beyond the stated intended purpose is deemed inappropriate. The
manufacturer accepts no liability for any damage resulting from this.
Modifications to the turbine and/or inverter are prohibited. The turbine and inverter may only be
used if safe to operate and in technically perfect condition.
Only a duly authorized representative of Vortex Hydrokinetics LLC may open the hermetically
sealed generator and magnetic coupling enclosures of the turbine.
The turbine and inverter must only be wired by a certified electrician who performs all necessary work in
strict compliance with the national and local codes, all applicable standards and regulations.
Work that could affect the electrical power system of the relevant energy supply company at the site of the
hydroelectric energy feed-in, may only be carried out by qualified electricians expressly authorized
and/or licensed by the energy supply company. The installer must always observe the rules and
regulations established by the energy supply company.
Make sure all electrical connections are tight, clean, dry, and protected from weather and
damage. Make sure all fasteners are installed and properly tightened.
Do not operate or work on the equipment if mentally or physically impaired, or after consumption
of alcohol or drugs. Under no circumstances children may operate, install or perform any
maintenance work.
Turbine's Generator and Magnetic Coupling are encapsulated within a
hermetically sealed enclosure. Exceptionally strong magnetic force is
present inside the enclosure. You can get severely injured by the steel
parts violently attracted to the permanent magnets.
Only a duly authorized representative of Vortex Hydrokinetics LLC may open the
hermetically sealed generator / magnetic coupling enclosure. Any unauthorized access
will immediately terminate the manufacturer's warranty, guaranty and general liability.
➢
Never disconnect the power connections of the generator while the equipment is energized.
➢
Wait at least five minutes before touching any components which are normally live.
➢
After switching off the generator, do not touch it until it has cooled down to ambient temperature.
Any instance of misuse or violation of any of the above stated conditions, requirements and procedures as
outlined in this manual will cause the immediate termination of the warranty, guaranty and general
liability of the manufacturer.
Vortex Hydrokinetics LLC © 2019
SETUR-M User's Manual - Rev. 2M-A
Page 5 of 24
